So my word is going to take up 1 3/4 inches, leaving 4 1/4 inches for knots and other beads, or 2 1/8 inch on either side of the letters. 25, and then the spaces between the letters are 4 times. The letter beads are 1/4 inch wide, and I want two knots between them (tying one with each side) which add 1/8 inch each. If you are leaving space, be sure to space out your beads the proper amount so you get an accurate length measurement.Įxample: I want my finished bracelet to be 7 inches around, so subtracting an inch for the fastening, that leaves 6 inches of beads and knots. You can butt the beads against each other, or tie a couple of knots between them to create a little space. Spell out your word with the letter beads, and measure how much length they will take up. Then subtract an inch for the fastening bits. Measure what size you want your finished bracelet by wrapping a piece of cord around your wrist. Measure and plan your letter beads and bracelet size.I kept the big eye needle attached on one cord, which served the same purpose and made it easy when it was time to add a bead, but it did make the knot tying a little trickier. You can do this with a marker pen, or nail polish, or something similar. It is very helpful to mark the end of the cord on one side so you can tell the sides apart. So make sure that the cord that you start with on the left, stays on the left, and the same for the right. Tip: The only trick to the knotted chain is to make sure the cords do not cross over as you are tying the knots and adding the beads. Repeat Steps 1 and 2 until you have the length you want. Basically you are just looping one cord around the other, alternating sides. The knot you will be using for the main part of the bracelet is called the knotted chain. If you are using a lighter, you don’t want them to fatten out as they melt, so quickly run your fingertips over the ends after you remove the flame. Using the cord cutter or lighter, melt the ends of the cords so they don’t fray. Tie an overhand knot at the halfway point, making a small loop about half an inch long, or just large enough to fit your button through. Friendship Bracelet with Beads - Step by Step InstructionsĬut a piece of cord one yard long.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |