Millimeters – enable this option to use metric units, where all work is done in millimeters.Inches – enable this option to use imperial units, where all work is done in mils (1/1000 inch).Use this region to choose the inherent units used in the generated file: The General tab of the Gerber Setup dialog Units Click Configure to the right of Gerber Files. At the PCB or schematic document level, click Home | Project | » Generate outputs to access the Generate output files dialog.Click Project | Project Actions | to access the Generate output files Click Configure to the right of Gerber Files.At the PCB document level, click Outputs | Fabrication |.This dialog can be accessed in the following ways: How to export SolidWorks PCB to Gerber files and NC Drill File How to export Allegro/OrCAD PCB to Gerber files and NC Drill File How to export CircuitMaker PCB to Gerber files and NC Drill File How to export Altium PCB to Gerber files and NC Drill File How to export Design-Spark PCB to Gerber files and NC Drill File How to export Diptrace PCB to Gerber files and NC Drill file How to export Eagle 9.2 PCB to Gerber files and NC Drill File How to export KiCad-5.1.5 PCB to Gerber files and NC Drill file How to export Gerber files from NI Ultiboard How to export Proteus PCB to Gerber files How to export Sprint Layout PCB to Gerber files and NC Drill file Gerber File Generation Guidelines for Cadsoft Eagle Surface Finishes for Printed Circuit Board
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |